Sumitomo Drive Technologies VP2500L, Руководство пользователя

Страница: 16 / 36

Storage and transport
Storage
The storage period starts when the device is not used.
Before storage:
• Drain the oil from the device. Refer to section
Drain the oil from the device
on page
26.
• Clean the wear indicator sensor. Refer to section
Clean the wear indicator sensor
on
page 29.
During storage:
• The ambient conditions for storage must be correct. Refer to section
Ambient
conditions
on page 31.
• Prevent damage to and/or deformation of the device.
Off-site transport
Caution: Prevent vibration of the device. Vibration can cause damage to the
components of the device.
• Move the device carefully to prevent damage to the device and its components.
• The device must be stable during transport.
• Secure the device to a surface to prevent unwanted movement of the device.
On-site transport
Warning: Let the device cool down before you lift the device. The device can
be hot.
Caution:
• Remove the LM2 Gears CMS unit before you transport the device. The
LM2 Gears CMS can fall from the device during transport.
Note: The LM2 Gears CMS unit is installed with magnets.
• Only install the LM2 Gears CMS unit when the device is in its final
operation position. To install the LM2 Gears CMS unit on the device, refer
to the user manual of the LM2 Gears CMS.
• Only lift the device at the frame. If you lift the device at the components on
the frame, damage to these components can occur.
5
5.1
5.2
5.3
Storage and transport
16
UM_VP2500L_002_EN