![background image](http://html.mh-extra.com/html/sumec/powerg-pg18chd/powerg-pg18chd_manual_1390548013.webp)
of your power tool. (Pic. B)
1) Connect Battery charger adapter (10) with battery charger base (12). Plug the
battery charger adapter (10) into AC voltage source.
There are 2 lights in the battery charger, red and green. Green lamp will light.
2) Slide the battery charger base (12) towards battery pack (8) according with
symbol “+” and “-“on the battery pack (8) and charger base( 12), both red and
green lamps will illuminate during charging process.
3) When the battery is fully charged (after approx 5 hours) the red light will fade
and the green light will remain lit
4) After charging, unplug the charger adapter (10) from the power source.
Note:
a) The battery charger is for charging PowerG battery packs. Never use it for other
purposes or for other manufacturer’s batteries.
b) When you charge a new battery pack or a battery pack which has not been used
for a long period of time, it may not accept a full charge. This is a common
situation and does not indicate a problem. You can recharge the battery pack
fully after discharging it completely and recharging a couple of times.
c) If you charge a battery pack from a just operated tool or a battery pack which
has been left in a location exposed to direct sunlight or heat for a long time, The
red charging light may flash. If this occurs, wait for a while. Charging will begin
after the battery pack cools. The battery pack will cool faster if you remove the
battery pack from the high capacity battery charger.
d) If the charging light flashes alternate green and red, a problem exists and
charging is not possible. The terminals on the charger or battery pack may be
clogged with dust or the battery pack may be worn out or damaged.
ASSEMBLY
Battery Charging
Only use the battery chargers that are matched to the nickel-cadmium battery
Содержание PowerG PG18CHD
Страница 2: ...A B C ...
Страница 22: ...Cordless Hammer Drill PG18CHD ...