3
1 General
1.1
Application areas
ATTENTION
The maximum allowable temperature of the medium pumped:
Sanimax R 202 & R 202C, Sanimax MF 154 & 324 = 40 °C
Sanimax MF 154HW = 80 °C
The Sanimax with Sulzer submersible pump has been designed for the dewatering of buildings below the sewer
level. It is suitable for faecal-free effluent in accordance with EN 12056/DIN 1986-100.
The Sanimax is a compact wastewater lifting unit which can be installed under or beside the wastewater source
at floor level.
In accordance with the regulations for effluent lifting stations, pumping of effluent containing faecal
matter, or the pumping of flammable or explosive fluids, is not allowed with these lifting stations.
Examples of substances that should not be allowed into the tank:
•
Aggressive fluids such as acids, lyes (caustic soda) or salts.
•
Flammable liquids such as petrol, oil or phenols.
• Commercial and agricultural waste.
•
Solid substances such as ash, rubbish, glass, sand, fibrous material, cardboard, paper towels, textiles,
diapers, kitchen waste, coffee grounds, shredder waste.
•
Liquid substances that can harden, such as bitumen, cement, lime, lime milk (whitewash), mortar, potato
starch, grease (edible oils and fats), synthetic resin, synthetic resin emulsion, tar, paint residues.
•
Cleaning agents, disinfectants.
• Abrasive material.
ATTENTION As
with all electrical devices, this product may fail due to operating errors, absence
of mains voltage, or even a technical defect. Such a failure may result in medium
or water escaping. If damage may occur due to the specific usage, measures
are required to avoid such damage arising. In this respect, taking account of the
conditions in question, particularly use of an off-grid alarm system, use of an
emergency generator, and provision of an additional and appropriately connected
second unit are to be considered.
Sanimax R 202 & R 202C, Sanimax MF 154 & 324
This product is only suitable for removing clear and dirty water up to a water temperature of 40 °C or
up to a maximum of 60 °C during short-term operation.
I
f the system is fed water from units such as washing machines, then the maximum water temperature
could be exceeded if the device is not equipped with discharge cooling or if this is not switched on,
e.g. in order to save energy.
This may cause damage to the pump or the pumping system. In such case Sulzer will not accept any
guarantee or warranty claim.
I
f necessary, contact the manufacturer of the device or devices provided for connection (e.g. washing
machines) to obtain information on how to switch on discharge cooling. If not possible then we
recommend installation of the Sanimax MF 154HW model (see below).
Our systems are checked in accordance with EN 12050 LGA and conform to the current standards.
Also note that the maximum inlet temperature to the public sewer system is 35 °C and that you must
ensure that the water is cooled accordingly.
Sanimax MF 154HW
Sanimax MF 154HW is designed for the pumping of high temperature liquids up to a maximum of 80 °C.
All inflow and discharge pipework to the unit must be temperature resistant accordingly
and is the
responsibility of the customer.
