Sulov Lifefit Bery, Инструкция по эксплуатации

Страница: 11 / 16

CARE AND HANDLING
-
Before each use, it is necessary to check the mountings are tight and for damage
of joints, bolts, wheels and other parts. Furthermore, make sure you fix the handle -
bar securely. Driving can be initiated only when the product is fully functional.
-
Before riding, always check the surface of scooters for any cracks. If so, the scooter
is not suitable for further use and must be replaced.
-
The product should be checked regularly with regard to wear and damage,
and to comply with safety requirements. Regular maintenance increases the safety
of your scooter. Do not use a damaged product.
-
Before riding, always check handling. If the wheels deviate to one side, it is neces -
sary to check whether they are properly tightened. If the wheel does not rotate
smoothly, it is necessary to lubricate the bearings with light machine oil. If the whe -
el still does not ratate smoothly or wobbles or are otherwise damaged they must
be replaced. Occasionally check the wheels and replace if worn out. If the wheel
surface is unevenly worn on one side, turn the wheel 180 degrees.
-
If there are self-locking nuts or other self-locking parts on the scooter with frequent
loosening and tightening they will lose their effectiveness. In this case it is necessary
to replace the working parts.
-
Do not make other adjustments to this scooter other than those described
in the instructions.
-
To clean, use warm soapy water and a soft cloth. Do not use solvents, paints,
adhesives and other aggressive agents and rough or abrasive materials that could
irreparably damage the product. Do not use abrasive cleaners that may scratch the
surface scooters.
INSTALLATION - REMOVAL
1. Loosen the screw on the folding mechanism, lift slightly and then pull the middle
lever up, thereby releasing the handlebar stem.
2. Lift the stem up. Once the stem of the handlebar at a right angle relative
to the foot plate (footboard), push the lever downwards, thereby clicks into
the second opening. Tighten the screw securely.
3. Loosen the screw clamp on the handlebar, pull it to the desired height, until
the snap button protrudes into the hole (outwardly) and securely tighten the quick
release screw clamp.
4. Fit the handles to the handle bar stem so that the snap buttons protrude
from their holes.
- To dismantle the scooter please reverse the above steps.
11