Sullair ShopTek ST1100, Руководство пользователя

Страница: 60 / 72

S
HOP
T
EK
™
USER MANUAL SECTION 6
58
02250180-090 R00
6.3 MAINTENANCE EVERY 2000
HOURS
After 2000 hours of operation:
1. Clean the return line strainer. Refer to Figure
6-1 and Figure 6-2 .
2. Replace the fluid filter. Refer to Figure 6-3
and Section 6.5 .
3. Pull fluid sample for analysis.
4. Replace air filter. Refer to
Figure 6-4 and
Figure 6-5 and Section 6.6 .
5. Check belt tension. Re-tension or replace as
necessary. Refer to Section 6.8 .
6.4 FLUID MAINTENANCE
Drain the separator tube and change the compressor
fluid using instructions shown in the Lubrication
Guide.
6.5 FILTER MAINTENANCE
Refer to Figure 6-3 . Replace the fluid filter under any
of the following conditions, or whichever occurs first:
1. Every 2000 hours a display on the Controller
indicates the need for replacement
2. Every fluid change.
F
LUID
F
ILTER
R
EPLACEMENT
Refer to Figure 6-3 .
1. Use a strap wrench to remove the filter and
gasket.
2. Dispose of filter properly.
3. Clean gasket seating surface.
4. Apply a light film of fluid to the filter gasket.
5. Hand tighten until gasket is seated.
6. Continue tightening filter an additional 1/2 to
3/4 turn.
7. Replace any lost fluid. Do not overfill.
8. Restart compressor and check for leaks.
Figure 6-2: Return Line Strainer
ST1100, ST1500, 15-20HP
1. Strainer
2. Separator Tube
NOTE
Dispose of fluids in accordance with
applicable federal, state and local
regulations.
Figure 6-3: Fluid Filter Assembly
1. Fluid Filter