Sullair LS-10 18KW 24KT, Руководство оператора и списки запасных частей

Страница: 44 / 90

Section 7
MAINTENANCE
38
TROUBLESHOOTING--STANDARD ELECTRO/MECHANICAL
SYMPTOM PROBABLE CAUSE REMEDY
COMPRESSOR WILL NOT BUILD Air Demand is Too Great Check service lines for leaks or open valves up
FULL DISCHARGE PRESSURE.
Dirty Air Filter Check the filter indicator and inspect and/or
change element if required.
Pressure Regulator Out of Adjustment Adjust regulator according to control
adjustment instructions in the Maintenance
section.
Defective Pressure Regulator Check diaphragm and replace if necessary
(kit available).
LINE PRESSURE RISES ABOVE Leak in Control System Causing Check for leaks.
CUT---OUT PRESSURE SETTING Loss of Pressure Signals
ON PRESSURE SWITCH
Defective Pressure Switch Check that diaphragm and contacts are not
damaged. Replace if necessary.
Defective Regulator Valve Check that air bleeds from control orifice
when the pressure switch contacts open.
Readjust; Repair or replace it if necessary (kit avail
able).
Plugged Control Line Strainer Clean strainer (screen and o’ring replacement kit
available).
Defective Blowdown Valve Check that sump pressure is exhausted to
the atmosphere when the pressure switch
contacts open. Repair or replace if neces---
sary (kit available).
High Pressure Shutdown Switch is Readjust or replace.
Defective or Incorrectly Adjusted
EXCESSIVE COMPRESSOR FLUID Clogged Return Line or Orifice Clean strainer (screen and o---ring replace---
CONSUMPTION ment kit available).
Clean orifice.
Separator Element Damaged or
Not Functioning Properly Change separator.
Leak in the Lubrication System Check all pipes, connections and compo---
nents.
Excess Fluid Foaming Drain and change.
Fluid Level Too High Drain and change.
PRESSURE RELIEF VALVE OPEN Defective Pressure Relief Valve Replace.
REPEATEDLY
Plugged Separator Check separator differential.
LIQUID WATER IN COMPRESSED Water Vapor Condensation from Cooling Remove the water vapor from compressed air prior
AIR LINES and Compression Occurs Naturally to distribution through the air system. Check opera---
tion of aftercooler and moisture separator. Install a
compressed air dryer sized for the flow and dryness
level required. (Note: Filters may also be required to
remove particulates, liquid oil aerosols or for oil vapor
removal. Change cartridges as recommended by the
filter manufacturerer). Check all drain traps routinely
to insure their proper operation. Maintain them regu---
lary.
7.10 TROUBLESHOOTING-- SUPERVISOR
II
The information contained in the Supervisor
II
Trou-
bleshooting chart is based upon both the actual ap-
plied situations and extensive testing at the factory.
It contains symptoms and usual causes for the de-
scribed problems. However, DO NOT assume that
these are the only problems that may occur. All avail-
able data concerning a problem should be system-