Sukup Sweepway, Руководство владельца по установке и эксплуатации

Страница: 23 / 92

Installation
23
Attach rear carrier wheel(s) to backboard as shown on Page 85. In bins 35’ dia. and larger, attach one
wheel about 3’ from center of bin and one about 3’ from drive wheel. In smaller bins, attach a single
wheel near middle of backboard. Ensure sumps will be missed by carrier wheel(s). Use orange
stickers on backboard as a guide.
NOTE: If bin has a stirring machine, trim its down-augers to avoid contact with sweep and 17” wheel.
Minimum clearance from any object is 6”.
ATTACHING SWEEP STOP
Bolt sweep stop to bin wall near door so it can be positioned without entering bin. Bottom of stop must be
1-1/2” from floor. For Sweepway with 17” drive wheel, add sweep stop extension (E5515) as shown in
Image 1 using two (2) 5/16” bolts and 5/16” flange nuts.
Mount sweep stop bracket to wall with four (4) 5/16 bolts w/ polyurethane washers, 5/16” fender washers
and 5/16” flange nuts. NOTE: Flashing bolts can be used to mount bottom of bracket. Holes for top of
bracket will have to be field-drilled.
Image 2 shows sweep stop retracted to let sweep pass.
Image 2 – Sweep stop retracted
SWEEP STOP
EXTENSION
(E5515)
Image 1 – Sweep stop extension added for
use with 17” drive wheel
STANDARD SWEEP STOP
(E5514) FOR 10” WHEEL)