Sukhoi SU-26, Инструкция по эксплуатации

Страница: 16 / 39

24. ‡ Glue the top T.E. SHEETING to the spars, ribs,
and the bottom T.E. sheet.
25. ‡ From the remainder of the edge-glued sheeting
used for the T.E., measure a width of 5-3/8” from
one end and 3-7/8” at the other end.
‡ With a straight-edge, draw a line from one mark
to the other. Then cut the sheeting along the
line, creating two tapered pieces.
26. ‡ Glue and pin the L.E. sheet to the shoulder on
the leading edge, the rib camber, and the spar.
27. ‡ Making sure the servo wire knock-out hole is on
the piece closest o the L.E., glue the three large
pieces of CENTER SHEETING to the ribs, the
L.E. and the T.E..
‡ Pre-fit a wedge-shaped piece of sheeting to fill
the center area.
‡ When satisfied with the fit, apply glue and slide
the piece into place, as shown.
28. ‡ Use a flexible straight-edge to trim the sheeting
flush with the wing centerline.
‡
Punch out the knock-out hole in the sheeting to
provide access for the servo wire.
16
T.E. SHEETING
L.E. SHEETING
L.E. SHEETING
5-3/8"
3-7/8"
FLUSH WITH T.E.
SLIDE
ON CENTERLINE
BREAK OUT