background image

Instruction 

Manual

SubSurface Instruments Inc.

GAIN

SSI

BATT

Signal Strength and Polarity (-) or (+) are indicated by the 

two opposite-facing bar graphs. The signal indications 

start in the  center-most short bars and fill outwardly in 

increasingly larger bars as the signal increases, until 

maximum strength is reached.

Polarity is indicated by which set of bars are being filled: (-) 

Negative  or  (+)  Positive Side

The Gain Setting in the lower left hand corner is the “GAIN” 

bar graph, indicating from left (low) to right (high). By 

raising the gain, the locator will become more sensitive to 

a weaker target.

The Battery Icon in the lower right corner only appears 

when the batteries are getting low. The shape of a battery 

appears when the batteries are very close to needing   

replacement. Once this starts flashing, only about 5% of 

the battery life remains. Always carry spare batteries in the 

carrying case and be prepared to replace batteries when 

the battery symbol appears. Extensive use of high volume 

settings will reduce battery life.

Magnetic Locator

ML-1

ML-1M

GAIN

ON

OFF

VOL

GAIN

ML-1 KEYPAD

Power On/Off:

 Press this button to turn the unit ON or OFF

Speaker Volume:

 is controlled by pressing and holding down 

the ON/OFF button. It will cycle from “Low”  through “High.” 

Repeat the cycle until the button is released. Release the 

button at the desired volume.

Gain (Sensitivity) Control Down and Up:

 

Depress the button with the “DOWN ARROW” to decrease the 

sensitivity and depress the “UP ARROW” button to increase 

the sensitivity. One click at a time.

Microprocessor Controlled:

 The Volume and Gain setting 

are set in processor memory. When the unity is turned off, it 

remembers the last settings, so that when you turn on the unit 

again, it will already be adjusted to your previous settings.

Battery Compartment

Loosen the Captive Screw located on the bottom of the 

electronics box and remove the cover. Two 9-volt battery slots 

are provided. Since there are no “snap” connections to make, 

be sure the batteries are placed in the correct “polarity”.

SubSurface Instruments Inc.

1841-C Plane Park Drive

DePere, WI 54115

Phone: 

(855) 422-6346

  •  

Fax: 920-347-1791

www.SSILocators.com  •   [email protected]

Отзывы: