Subaru Legacy Outback 2006, Руководство пользователя

Страница: 119 / 456

3-12
Instruments and controls
T
Vehicle communication system
fault indication
The vehicle communication system car-
ries various types of information (vehicle
speed, running conditions, etc.) to control
modules. In the event of a fault in this
communication system, the trip meter will
show “
”.
If the trip meter shows “ ”, we recom-
mend that you immediately contact the
nearest SUBARU dealer and have the ve-
hicle communication system inspected.
NOTE
If you press the trip knob while the trip
meter is showing “
”, the trip meter
indication will appear for 10 seconds.
„
Tachometer
The tachometer shows the engine speed
in thousands of revolutions per minute.
NOTE (3.0-liter models only)
To protect the engine while the vehicle
is not in motion, the engine is con-
trolled such that the engine speed
does not become too high even if the
accelerator pedal is pressed hard.
„
Fuel gauge
The fuel gauge shows the approximate
amount of fuel remaining in the tank.
The gauge does not return to “E” even
though the ignition switch is in the “ACC”
or “LOCK” position.
The gauge may move slightly during brak-
ing, turning or acceleration due to fuel lev-
el movement in the tank.
If you press the trip knob while the ignition
switch is in the “LOCK” position, the fuel
gauge’s dial will light up and the needle
will indicate the amount of fuel remaining
in the tank.
If, while the fuel gauge needle is indicating
the amount of fuel remaining in the tank,
you (a) do not press the trip knob for 10
seconds or (b) open and close the driver’s
Do not operate the engine with the
pointer of the tachometer in the red
zone. In this range, fuel injection will
be cut by the engine control module
to protect the engine from overrev-
ving. The engine will resume run-
ning normally after the engine
speed is reduced below the red
zone.
300263