Subaru impreza 2017, Руководство пользователя

Страница: 713 / 786

SEMOD117441-2 v5
Table 565: SLM – SPA/IEC 60870-5-103/DNP3 port
Quantity Range or value
Optical connector Glass fiber: type ST
Plastic fiber: type HFBR snap-in
Fiber, optical budget Glass fiber: 11 dB (1000m/3000ft m typically *)
Plastic fiber: 7 dB (25m/80ft m typically *)
Fiber diameter
Glass fiber: 62.5/125 m m
Plastic fiber: 1 mm
*) depending on optical budget calculation
17.2.11 Galvanic RS485 communication module
SEMOD174899-1 v1
17.2.11.1 Introduction
SEMOD158664-5 v3
The Galvanic RS485 communication module (RS485) is used for DNP3.0 and IEC
60870-5-103 communication. The module has one RS485 communication port.
The RS485 is a balanced serial communication that can be used either in 2-wire or
4-wire connections. A 2-wire connection uses the same signal for RX and TX and
is a multidrop communication with no dedicated Master or slave. This variant
requires however a control of the output. The 4-wire connection has separated
signals for RX and TX multidrop communication with a dedicated Master and the
rest are slaves. No special control signal is needed in this case.
17.2.11.2 Design
SEMOD158668-1 v1
SEMOD158670-4 v3
RS485 is a PC-MIP card, and it is factory mounted as a mezzanine card on the
Analog digital conversion module (ADM).
RS485 connector pinouts
SEMOD158670-10 v1
The arrangement for the pins in the RS485 connector (figure 315 ) are presented in
table 566 :
Table 566: The arrangement for the pins
Pin Name 2-wire Name 4-wire Description
1 RS485+ TX+ Receive/transmit high or transmit high
2 RS485– TX– Receive/transmit
3 Term T-Term Termination resistor for transmitter (and receiver
in 2–wir case) (connect to TX+)
4 N.A. R-Term Termination resistor for receiver (connect to RX
+)
5 N.A. RX– Receive low
6 N.A. RX+ Receive high
1MRK 505 384-UEN A
Section 17
IED hardware
Breaker protection REQ650 2.2 IEC 707
Technical manual