-
3
-
PRECAUTIONS
• Please refer to the precautions below before you begin work, in order to install the product safely and accurately
Please also refer to the vehicle Service manual.
• This manual shows typical installation procedures on LHD vehicle. Installation will be mirror image for RHD vehicles.
ATTENTION
• Please disconnect the battery cable while conducting wiring operations. Failure to do so
may result in electrical shock or injury.
•
. Also,
please make an note of data in the memory of the electrical components such as the
radio. This will help avoid problems that may arise when performing the repair check after
the installation.
• When tightening bolts or screws, use the proper tools and the proper size, and comply for
Failure to securely tighten the bolt and nut may cause them to loosen and fall off, causing
damage.
• When removing the connector from the vehicle, remember to remove the lock that holds
the main body of the connector, instead of pulling the lead line.
This protects against a lead wire cuts, etc.
• Please be sure to properly connect the connector and terminal. This helps to avoid a poor
connection.
• When wiring the harness(wiring), clamp the wires together along with the wiring harness
of the vehicle. This protects the harness from becoming entangled or causing strange
sounds.
•
, etc, be
careful not to let the harness be hooked or pulled from the back. This protects against a
cut wire or shorts.
• Be careful not to forcefully pull the wiring harness of the vehicle. This helps prevent the
connector from being disconnected, and the wires from being cut or damaged.
• After installing the wiring, perform an operations check on the newly installed parts before
reassembling. This helps prevent mis-wiring.
