Subaru 2008 IMPREZA, Руководство пользователя

Страница: 132 / 381

3-24
Instruments and controls
thieves by indicating that the vehicle is
equipped with an immobilizer system. It
begins flashing (approximately once every
3 seconds) approximately 60 seconds
after the ignition switch is turned from the
“
ON
”
position to the
“
Acc
”
or
“
LOCK
”
position or immediately after the key is
pulled out.
If the security indicator light does not flash,
the immobilizer system may not be func-
tioning properly. If this occurs, contact
your SUBARU dealer as soon as possible.
In case an unauthorized key is used (e.g.,
an imitation key), the security indicator
light illuminates.
NOTE
Even if the security indicator light
flashes irregularly or its fuse blows
(the light does not flash if its fuse is
blown), the immobilizer system will
function normally.
&
SPORT mode indicator
light (AT vehicles)
This light comes on when the ignition
switch is turned to the
“
ON
”
position and
goes out after the engine has started.
When the selector lever is moved to the
manual gate, the SPORT mode is se-
lected and the indicator light comes on.
Refer to the
“
SPORT mode
”
section in
chapter 7.
&
Selector lever and gear posi-
tion indicator (AT models) (if
equipped)
This indicator shows the position of the
selector lever.
When the manual mode is selected, the
gear position indicator (which shows the
current gear selection) and the upshift/
downshift indicator light up. Refer to the
“
Automatic transmission
”
section in chap-
ter 7.
&
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to the
“
Replacing bulbs
”
section in
chapter 11.
&
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also comes on when
the headlight flasher is operated.
&
Cruise control indica-
tor light
The cruise control indicator light comes on
when the ignition switch is turned to the
“
ON
”
position and goes out after approxi-
mately 3 seconds.
This light comes on when the
“
CRUISE
”
main switch is pressed.
If you press the main switch button while
turning the ignition switch
“
ON
”
, the cruise
control function is deactivated and the
“
CRUISE
”
indicator light flashes. To re-
activate the cruise control function, turn
the ignition switch back to the
“
Acc
”
or
“
LOCK
”
position, and then turn it again to
the
“
ON
”
position.