Page 28
V-Series Cooktop Hoods
V-Series Cooktop Hoods
Technical Data
5-2
#825309 - Revision A - August, 2014
Technical Data
This Technical Data Section has been compiled with the latest information from Faber S.p.A. Company.
600 cfm Internal Blower
414 WATTS
115 VAC
3.6 AMPS
Note:
All measurements in Watts, Voltage, or amps are approximate. Actual readings can very plus or minus 10
percent.
General Hood Information:
Light System is 12 VDC.
•
Three wire harness from Power Board Assembly to Transformer is Light Control Circuit and is 12 VDC.
•
Blower speed is controlled by a Triac on the Power Board Assembly.
•
General Use and Care Information:
Delay mode lasts for 10 minutes.
•
Activate Boost by holding Hi for 3 seconds. Boost is on for 10 minutes, then returns to prior speed.
•
Boost increase air flow by approximately 20%.
•
Approximately 100 hour to activate Filter Alarm.
•
LED Assembly is S1000 LED Natural White 4000k.
•
Remote Control takes 2 AAA batteries.
•
Black Hood Use and Care Information:
Hood flashes FC for Recirculation Filter alarm and FG for Mesh Filter alarm. No matter which filter system is
•
being used the hood will flash both FC and FG.
Hold Delay for 5 seconds to reset Filter Alarm. Hood will flash FF when reset.
•
Hi is displayed for Boost.
•
Activate or Deactivate Remote Control by holding On/Off for 5 seconds.
•
Hood flashes IR when Remote Control is activated or deactivated.
•
Stainless Steel and Glass Hood Use and Care Information:
Hold Filter for 5 seconds to reset Filter Alarm.
•
High Blinks when in Boost.
•
Activate or Deactivate the Remote Control by holding Delay for 5 seconds with Lights and Blower Motor off.
•
On/Off and Low flash twice when Remote Control is activated or deactivated.
•
