11
12
13
14
15
E1 Parameter
Function : Relay status on
Probe Failure.
press the
SET key.
To change
the E1
parameter
Use UP/DOWN keys to set desired
value.
0 = Relay status is ON.
1 = Relay performs a duty cycle
OFF.
2 = Relay status is OFF.
When set to
10 minutes ON and 4minutes
0
2
1
Min
Max
Fac.
RS = 0 / 1
PO Parameter
Function : To enable/disable Power
Switch.
To change
the PO
parameter
press the
SET key.
0
1
0
Min
Max
Fac.
RS = 0 / 1
If press for 2 seconds controller will
go in stand by mode, display will
show “OF”. To again switch to
ACTIVE WORKING MODE, press
power switch again for 2 seconds.
All leds and 7-segment display will
flash and enter into NORMAL
WORKING MODE.
Use UP/DOWN keys to get desired
value & press SET key to confirm.
0 = Disable power switch
Controller has power switch, which
if enable puts controller in active or
stand by state.
1 = Enables power switch
RS Parameter
Function : To change the resolution.
To change
the FS
parameter
press the
SET key.
0
1
0
Min
Max
Fac.
RS = 0 / 1
Use UP/DOWN keys to set desired
value.
Note : Temperature and parameter
will also change accordingly.
If this parameter when set to 1,it will
0
take all parameter in 1 C resolution.
If this parameter when set to 0,it will
0
take all parameter in 0.1 C
resolution.
LP Parameter.
Function: To lock keypad.
To change
the LP
parameter
press the
SET key.
1 = keypad locked
This parameter can lock the keypad
so that tampering is not possible by
by-standers.
0 = keypad unlocked
When locked all parameters can
only be viewed, but not modified.
Use UP/DOWN keys to set desired
value.
0
1
0
Min
Max
Fac.
RS = 0 / 1
FS Parameter
Function : To restore default
settings of the controller.
To change
the FS
parameter
press the
SET key.
0
1
0
Min
Max
Fac.
RS = 0 / 1
When set to 1 all parameters are
programmed to factory values.
Useful to debug setting related
problems.
16
EP Parameter
To end
programming
press the
SET key
Once the SET key is pressed, the
control goes into the normal mode
and displays the temperature and all
settings are recorded.
Function: To end programming.
