|
13
subzero-wolf.com.au
BUILT-IN REFRIGERATION
Custom Panels
FLUSH INSET PANELS
The flush inset application is an overlay model with flush
inset panels. It is not a separate model.
The flush inset design allows custom panels to be installed
flush with adjacent cabinets. Similar to overlay, flush inset
panels are typically created by combining a 19 mm custom
panel, a 3 mm spacer panel and a 6 mm backer panel. Refer
to the illustrations for overlay panels. Panels must be fixed
together prior to installation.
For flush inset panels thicker than 19 mm, a 90° door stop
may be required to prevent interference with adjacent
cabinets. Refer to the full-scale templates at the end of this
guide.
When installing two units side by side, refer to page 18 for
dual flush inset installations.
ICE | WATER DISPENSER
For model ICBBI-48SD, the refrigerator door panel must
include a cut-out to accommodate the external dispenser.
The thickness of the panel in this area can range from 6 mm
to a maximum of 29 mm. Refer to the illustrations below.
160 mm
2 mm
3 mm
RADIUS
16 mm
327
mm
51
mm
25
mm
HANDLE
GLASSWELL
Dispenser dimensions.
Handle placement.