USE INSTRUCTIONS
Up & Down Movement:
Press the UP arrow continuously, the legs will move up
Press the DOWN arrow continuously, the legs will move down
Release arrows to stop movement.
Memory Preset Positions:
Use the UP and DOWN arrows to set table at a desired height.
Press the POSITION SETTING BUTTON (S) followed by one of the 4 PRESET POSITION
BUTTONS(1 2 3 4) buttons. The memory position is set.
There are up to 4 presets available. To return to a memory preset press the desired number.
Warning:
It is recommended that the legs not be moved up and down continuously for more than 2
minutes within a 20 minute interval or exceed the lift capacity.
To avoid over loading the transformer an overload protection program is built into the system.
If the unit stops working let it cool off before trying to raise or lower it again.
If the unit overloads the LED display will display "HOT".
Reset:
Press the DOWN button and lower the desk to its lowest setting..
Press the DOWN Button again for ~ 5 seconds until the LED reads “RST”
Press the DOWN button & hold it while the legs move up & down to level and stop.
Release the DOWN button as the reset is now complete and your table is ready to use.
Error Code Key:
E02 –unbalanced, keep the desk moving will auto matically adjust it to balance state
.
E04 –overload,move something off the desk to reduce the loading weight.
E05 – resistance to return
.
R5T - means “reset” cycle in progress
.
Er8 – miscommunication between control box and legs plugged into port 1
.
Er9– miscommunication between control box and legs plugged into port 2
.
HOT –desk has reached its duty cycle limit – let desk base cool for 20 minutes.
Page9
