Oct 8, 2015
○
E
TROUBLE SHOOTING
1. If the blade does not spin, make sure the two blades are assembled
correctly. The front side of the blades (where the ball bearing is visible)
should face outside. The backside of blades (where the ball bearing is
covered) should face inside.
The two blades should face opposite
directions.
2. If one blade is spinning while the other one is not, or if one blade is spinning faster than the other, pay attention to below:
A. Rotate the T-Bar so that the two blades are facing the direction of the wind, or
B. Wait until the wind is stronger. Wind speed and/or direction change may cause one blade to spin faster than the other.
3. The two Blades (B & C) are designed to spin in opposite directions. If wind speed or direction change, they may spin in the
same direction. Wait until the wind is at a steady speed to experience proper spinning.
WARNINGS & CAUTIONS
1. This item is not a toy.
DO NOT ALLOW CHILDREN TO CLIMB ON, HANG FROM, OR PLAY WITH THIS ITEM
.
2. When the blades are spinning at a high speed,
DO NOT TRY TO TOUCH BLADES AS IT MAY CAUSE INJURY.
3. Remove the T-Bar and Blade Assembly when the wind speed reaches 50 MPH or greater.
CARE & MAINTENANCE
To clean, use a soft cloth or sponge. To avoid damaging the finish, DO NOT USE ABRASIVE CLEANERS OR STEEL WOOL.
Made In China