27
_______________________________
ENVELOPE GENERATOR
REFLEX-PRO-X provides two identical ENVELOPE GENERATOR modules as modulation source. Each can operate as
ordinary envelope generator or as gate generator. The input signal passes a GAIN and the HIPASS/LOPASS stage
before reaching the envelope detector.
SOURCE:
Input source of the envelope generator. Available sources are plug inputs and all individual slot outputs
[determined by the direct out setting] with left/right and mono sum options as well as an additional side
chain input or the MASTER FX mono sum.
MODE:
Operation mode [ENVELOPE/GATE]
OUTPUT:
Switch between
Linear and Logarithmic output
MONITOR:
If activated the processed envelope input is directly routed to the plugs output. Use this to test and
find proper envelope settings.
Be careful with high GAIN settings!
GAIN:
Gain of the envelope input signal. [0dB - 40dB]
LOCUT:
Cutoff frequency of the envelope input Hi-pass filter. [50Hz - 10kHz]
HICUT:
Cutoff frequency of the envelope input Lo-pass filter. [100Hz - 20kHz]
DEPTH:
Output range of the ENVELOPE GENERATOR. [0%- 100%]
THRESHOLD:
[
available in GATE mode
] Threshold level to trigger the gate. [-90dB - 0dB]
ATTACK:
Attack time until the
ENVELOPE GENAERATOR reaches full output level. [0ms- 5000ms]
HOLD:
[a
vailable in GATE mode
] Hold time until the ENVELOPE GENAERATOR triggers release mode
after gate reached full output. [0ms- 10000ms]
RELEASE:
Release time until the ENVELOPE GENERATOR reaches zero level after elapsed hold time.
[10ms- 15000ms]
VU METER:
Visual level control. The white line
represents the actual input level. The red line
represents
the threshold level. The full red bar represents the
actual
ENVELOPE GENERATOR output.
©
2020-2021
doc version 1.2.0
