Trigger Set Screw Replacement
1. Use a 1/16” hex key to remove the Trigger Set Screw.
2. Apply two drops of Perma-Lok MM115 thread adhesive (or equivalent) to the leading threads on the new
Trigger Set Screw. This prevents loosening of the screw during wrench use.
3. Insert the replacement Trigger Set Screw into the hole and into the tapped hole in the tang. Snug the Trigger
Set Screw with the 1/16” hex key.
Tang Replacement
If it is necessary to replace the tang, please contact your distibutor to determine and order the correct tang for
the tool. The Trigger Set Screw will need to be removed before replacing the tang, and reinstalled after the tang
is replaced. See the procedure immediately before this one.
Ratchet Replacement (SLTCR Only)
To replace the ratchet you will need a pair of inside snap ring pliers, a 1/8” or 3mm flat tip screwdriver and the
correct Ratchet Renewal Kit (P/N 816997).
1. Use the snap ring pliers to remove the snap ring.
2. Lift the square drive and washer straight out of the ratchet housing.
3. Remove slide pin and ball. Use caution - the ball is under the slide pin and is spring loaded.
4. Remove the spring.
5. Clean the inside of the ratchet housing thoroughly.
6. Insert the new spring into the recess for it.
7. Place the new ball on the spring.
8. Use the flat tip screwdriver to compress the ball and spring while sliding the new slide pin over them until
both sides of the housing are engaged by the slide pin.
9. Center the slide pin and insert the new square drive into the housing.
10. Place the new washer on the square drive.
11. Use the snap ring pliers to install the new snap ring.
Care and Cleaning
Always store the wrench in a clean and dry environment. To clean the wrench wipe off dirt and grease with a
clean moist cloth. Do not immerse the wrench in cleaning fluids. If the wrench is to be stored for an extended
period of time, return the wrench to its’ lowest torque setting (20% of capacity) before storing it.
Repair Parts, Service, and Certification
Repair parts, service and certification may be obtained through your S/R distributor.
Any style or type of device that changes the overall length of the wrench when used on it will have an effect on
the torque output. Always set the torque with such device in place.
Caution
•
Always wear safety glasses when working with hand tools.
•
Always make certain that the fastener engagement device properly engages the fastener before applying
torque.
•
Do not exceed the rated capacity of the torque wrench for any reason.
•
Every torque wrench should be checked for accuracy periodically.
For further assistance or parts diagrams, contact us using the information provided on the front of this document.
857010E
