Operation & LED's
Once the tool has been preset, the appropriate interchangeable head installed and the radio transceiver has been
associated with the appropriate controller and specifications exchanged, the tool is ready for use. In normal operation,
the tool will emit a strong tactile and sound impulse when it clicks. If the tool is jerked (too little time in the clicked
position) the LED on the tool will not illuminate. If the tool has been properly used (force applied, click attained, force
released within specified time frame) the LED on the circuit board will illuminate with a green color. This will shine
through the cover and be highly visible. If the tool has been pulled past the click (too much time in the clicked position)
the LED on the circuit board will illuminate with a red color. Under either of the latter two circumstances, the information
will be immediately transmitted to the controller.
SLTCR (Ratcheting) Models
These tools use the
SR
slide pin ratchet design to permit the user to reposition the body of the tool in limited-access
applications where a socket is used. Even though the ratchet is reversible, the tool only applies measured and controlled
torque in the clockwise direction, so thought must be given to the task to be accomplished before the ratchet is reversed
and the tool used in the counter-clockwise direction. Exceeding the capacity of the tool in a CCW torque application is
likely to damage the tool and is not covered by warranty.
The ratchet should be disassembled and cleaned periodically, then the ratchet spindle teeth lubricated very lightly with a
grease containing molybdenum disulfide prior to reassembly. For detailed instructions on ratchet disassembly cleaning
and reassembly, go to the FAQ section of our website.
SAFETY
•
ALWAYS wear safety glasses and all other required safety equipment when operating this tool.
•
Do NOT exceed the rated capacity of the wrench.
•
Do NOT use this wrench for any purpose other than that for which it was designed and manufactured.
Cleaning
This wrench should be cleaned with a soft cloth dampened with water. Do not immerse this tool in liquid or use any
solvent other than water to clean the tool.
Presetting, Calibration and Repair
Factory presetting and calibration from our ISO 17025 Accredited Calibration Laboratory are available. Contact your SR
distributor for details. Parts and factory repair are also available.
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guaran-tee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* Consult the dealer or an experienced radio/TV technician for help.
This equipment has been certified to comply with the limits for a class B computing device, pursuant to FCC Rules.
Operation with non-approved equipment is likely to result in interference to radio and TV reception. The user is cau-
tioned that changes and modifications made to the equipment without the approval of manufacturer could void the
user's authority to operate this equipment.
Additional Information
Additional information is available a
t
www.srtorque.com
. You can also call customer service at
1-847-455-8677 or e-mail them at [email protected]
. Part number 857330
Rev B
7/6/2015