Sturtevant Richmont
- P/N 857285 - Issue Date 100407 - Page 4 of 14
Other Icons
There is a battery icon in the upper right-hand quadrant of the screen above the units of measure. This icon
and other indications are used to warn the user when the battery voltage drops to a level where the batter-
ies should be replaced.
There are two icons used in normal operating mode (during performance of a task) to provide a quality at-
tribute indication for a just-completed fastener. The “OK” and “BAD” icons are located along the bottom of
the display on the left side. When a torque application is completed and the fi nal torque result is compared
to the torque specifi cation values for the task, an attribute evaluation is made and the appropriate icon is
illuminated briefl y.
Definitions
Target
A specific torque value: the midpoint between the minimum and maximum torque specifi-
cation values for the task.
Peak
Mode of operation capturing the highest torque value in a single loading of the wrench.
Residual
Mode of operation for capturing the torque remaining on a previously-installed fastener. In
this mode the tool captures the lowest point between two peaks; the peak torque to begin
fastener motion (includes inertia) and the peak torque where force application stopped.
Stored
Mode of operation used to review torque values currently stored on the tool.
Task
A set of from 1 - 50 torque applications grouped together and sharing common unit of
measure and torque value specification. Tasks are numbered from “00” to “50”.
Record
A single torque application within a specific Task. Numbered from “00” to 50. Record 00 is
designed to give the user the ability to use the specifications for the active task on a
fastener without recording the result.
UOM
Currently active Unit of Measure for torque. IN.LB, FT.LB, Nm
Clear Button
Clear the current reading from the display and, if in a task or record other than “00”, begin
storing information at the current point.
Select Button
Used to enter, select, and exit various options on the tool itself.
Up Button
Used to move (increment) upwards among options and increment levels within a selected
option.
Down Button
Used to move (decrement) downwards among options and increment levels within a
selected option.
Task 00
A special task always available, even when specific tasks have been downloaded to the
tool. When Task 00 is displayed, the tool functions as a torque wrench with no memory of
the torques applied, similar to a beam or dial wrench. When there is no job on the tool,
the default settings for the tool will be applied.
Yellow Light
Color (orange- yellow) projected onto display to indicate that the warning torque level has
been reached during use and that the speed of force application should be slowed. Use
of the LED color scheme is selectable in the software (active or inactive). Warns user that
the torque specification is being approached. Used in all Tasks numbered 01 and above
when record 01 and above are active. Not available in “Task 00” or “Record 00”.
Green Light
Color projected onto display to indicate that the current torque is within the limits of the
minimum and maximum torque specified for that Task. Use of the LED color scheme is
selectable in the software (active or inactive). Active in all Tasks numbered greater than
“00”. Not available in “Task 00” or “Record 00”.