3
3. CLIP Indicator:
The LED flash lights to indicate that the signal is clipping, please reduce gain level till the LED stops glowing.
4. 6dB or 15dB Range Mode Selector:
This knob is used to switch between ±6dB and ±15dB Range Mode. When the
knob is in the “pressed” position the ±6dB range mode is active, & when the knob is in the “release” position the ±15dB
range mode is active.
5. 6dB or 15dB Range Mode Indicator:
These LED's indicate the status of 6dB or 15dB Range Mode.
6. EQ In/Out Switch:
This knob is used to activate the EQ In/Out mode. EQ Out means that the effect of the EQ is bypassed.
When the knob is in the “pressed” position the EQ Out mode is active, & when the knob is in the “release” position the EQ
IN mode is active. (EQ Out is also be referred as Bypass feature commonly)
7. EQ Status LED:
This LED lights up when the EQ Out mode is in operation. EQ Out indicates that the EQ is bypassed.
8. Low Cut:
This knob is used to cut / attenuate signals below 30Hz. The Low Cut is activated when the button is in
“pressed” position.
9. Low Cut LED:
This LED lights up when the Low Cut mode is in operation.
10. Output Level:
This knob is used to control the master output from the equalizer.
NOTE:
Channel 1 and 2 are identical.
11. Signal Input Connector:
The SEQ 152 has both XLR & TRS (Phono) input connectors.
12. Signal Output Connector:
The SEQ 152 has provisions for both XLR & TRS (Phono) output.
13. Ground or Lift:
The Ground Lift switch eliminates unwanted hums and buzzes by interrupting ground loops between
equipment. You can use the provided switch change the two modes.
14. AC Cord & Fuse:
Plug the supplied cord into the power supply socket (Before using the product, check if the power
supply is correct). If the fuse is broken, please replace with a fuse of the same type.
Rear Panel Introduction
Input Impedance
Output Impedance
Input Output Connectors
Frequency Response
EQ Center Frequency
Low Cut
S/N Ratio
THD
Power Supply
Power Consumption
Dimensions (WxDxH)
Weight
Unbal: 10 K Ohms, Bal: 20 K Ohms
Unbal: 300 K Ohms, Bal: 150 K Ohms
XLR & TRS
20Hz - 20 KHz
25 Hz, 40 Hz, 63 Hz, 100 Hz, 160 Hz, 250 Hz, 400 Hz, 630Hz, 1KHz, 1.6 Khz,
2.5 KHz, 4 KHz, 6.3 KHz, 10 KHz, 16 KHz.
Below 30Hz, -20dB
> 90 dB
0.05%
230 V AC (50~60Hz)
20W
483 x 170 x 44.5mm
2.90 Kg’s
4. Technical Specification:
12
11
13
14
Содержание SEQ 152
Страница 4: ......
