Studiomaster DQX Series, Руководство пользователя

Страница: 8 / 32

07
2
、
Cooling Vents
:Front-to-rear forced airflow through foam dust filter.
3
、
LCD Display Screen.
4
、
Control Button
:
turn for previous and next ,push for enter.
5
、
Power Switch
:
ON/OFF . It is ON to press “I” down .
6
、
Power cord
:
Configuration 3×1.0mm², 3×1.5mm² or 3×2.5mm² cord according to power .
7
、Fans:Provide front-to-back forced airflow for cooling.
8
、
Output sockets.
To wire stereo or mono speakers to the Output sockets, use below method:
To wire Bridge speakers to the Output sockets, use below method:
2+
1-
2-
1+
+
-
CH-A/B/C/D
8Ω
4Ω
2Ω
b 、 encoder, as shown in the following figure ；
Setting considerations ：
I 、 485 address setting range: 1-255, 485 address of equipment under the same bus cannot be
repeated ；
II 、 The baud rate range is 1920-115200, and the baud rate of the equipment under the same
bus shall be set to be consistent; the baud rate shall be set according to the transmission
distance and rate. The lower the baud rate is, the farther the transmission distance is. The
higher the baud rate is, the closer the transmission distance is. It is recommended to set
3840
；
c 、 Open the upper computer software of the computer, click "search", the amplifier under the
bus will be displayed in the list, double-click or right-click to enter the power amplifier
configuration interface;