5
4. Output Section
(Please refer to the diagram on Pg. 3)
12. Master (L/R) Output:
This output is used to connect the master output of the mixer to the amplifier or powered
speakers. The output level is determined by the master fader (25). Wiring configuration is as follows :
Note:-
Please check Note 2 on page no. 10.
Pin 1 = Ground
Pin 2 = Hot (+ve Phase)
Pin 3 = Cold (-ve Phase)
13. Left & Right Send/Return Sockets:
This ¼” 3 pole jack socket is an effect send and return, or insert point,
which allows the signal on the individual outputs to be treated by an external processor in the same way as an
input channel or group.
14. Stereo Aux Input Sockets:
The Stereo Aux Input sockets are ¼” 2 pole jack unbalanced line inputs, designed
to be used as stereo inputs, to return signals (that have been externally processed) to the console. If a mono signal
is sent to the console, connect the left/Mono socket only.
15. Aux Master Send Sockets:
The Aux Master Sends are the main outputs from Aux Sends 1 to 4 to effects units
or monitor systems, they contain the sum of all signals sent from the Aux controls on the input channels. The Aux
Master Sends are ¼” 2 pole jacks.
16. Aux Master Send Controls:
This control is used to adjust the overall level of signals that have been sent to the
Aux bus by the controls on the individual input channels. The signals are accessed from the Aux Master Send
sockets.
17. Stereo Aux Input controls:
The two stereo Aux inputs are both well equipped to make the most of any
external effects unit, or use as extra stereo or mono line inputs. The level control sets the amount of signal coming
into console. The balance control sets the Left & Right balanced of the Aux return, and therefore the position of
the sound within the main stereo image. The Aux 4 control allows the Aux return to be routed to Aux 4 (the
primary foldback Aux) so effects or other signals can be heard, at the desired level, through the on stage
monitor speakers. Aux return can be routed to master by (L-R) or Group by (G1-G2) switch.
18. Bargraph:
It is equipped with 12 segment, two color LED’s. Bargraph can be assigned to Master, Group or
Mono-PFL by Mix-GR & Mix-GR/M+PFL Switch.
19. Headphone Out:
The ¼” Headphone Output socket carry the signal from the Left/Right, Group 1/2 & PFL
signal outputs. Please do not use headphones less than 400 impedance however it will safely operates at 8 Ω
with lower output level. Wiring configuration is as follows :
Sleeve = Ground
Ring = Return (To Console)
Tip = Send (To Effects)
Tip = Signal
Sleeve = Ground
Tip = Signal
Sleeve = Ground
MIX/GR
MIX-GR/M+PFL
Master (L & R)
Bargraph Out
Group (1 & 2)
Mono & PFL
(Release)
(Release)
(Press)
(Press)
(Release)
X
(Don’t Care)
