7
38. Monitor Output:
These outputs let you listen to any PFL, Mix, Group-Mix from a group or the 2-Track tape return on an external
amplifier & speakers. The monitor output lets you hear the mix that is going to the FOH; thereby helping you set mix levels.
37. Monitor Control:
This knob is used to control monitor output.
39. ST1/ST2 out (Stereo Aux Send):
ST1 and ST2 output is provided to connect to external auxiliary devices or monitor amplifiers.
42. ST1/ST2 Pan:
This knob can be used to Pan/Balance the incoming signal between the Left & Right output channels when the
signal is routed to the Main output.
40. ST1/ST2 Level Control:
This knob is provided to control ST1 and ST2 output levels.
41. ST1/ST2 EQ:
ST1/ST2 has 2 Band EQ.
43. ST1/ST2 to L-R Switch:
This switch is used to route ST1/ST2 signal to the Main output.
44. Sub On/Off Switch:
This switch is used to switch between Mono & Sub output.
45. Sub Frequency control:
This is used to sweep the Sub frequency between 80Hz to 120Hz.
46. Mono/Sub level control:
This knob is used to control Mono/Sub output level.
47. AFL Switch:
When pressed this switch routes the Mono output to headphone out.
48. Mono/Sub Output:
This XLR output is provided to connect to external auxiliary devices or monitor amplifiers. If Sub On/Off
switch is On then we get Sub output otherwise Mono output.
HF Control:
The HF control can be used to cut or boost up to +/- 15dB at 12 kHz.
LF Control:
The LF control can be used to cut or boost up to +/- 15dB at 80Hz.
49. Lamp +12V:
Lamp socket is provided to c12V standard lamp.
5. Effects Section:
50. Program Control:
This knob sets the required effect.
51. Parameter Control:
This knob sets the effects level.
52. Tap Switch:
Tap switch is used to adjust the Tap delay.
54. EFX Mute Switch & LED:
This switch is used to mute the EFX signal & it is indicated by the LED.
53. Tap Socket:
Tap socket is provided to adjust the Tap delay externally.
55. EFX Routing Switches :
These switches are used to route the EFX signal to the Main output, Group outputs & PFL.
56. EFX Fader:
This fader controls the effect level.
34. Level Meters:
Tip:
These 3-colour LED Meters are provided to monitor the output levels .
Keep the signal within the Yellow LED at peak levels for best performance.
35. Phones Level:
This knob is used to control the level of the headphone as well as monitor output.
36. Headphone Jack:
Adjust volume to
avoid hearing damage.
This is used to monitor Main output or PFL on individual channel using headphones.
33.
:
Power LED
This LED glows when power is being supplied to mixer.
Following Features are available in AiR Pro 28 & AiR Pro 36:
32. PFL Led:
This LED illuminates when the PFL is made active on any channel.
58. AC Inlet:
Use the supplied AC cord to connect the unit to AC mains. The fuse can be accessed by the small drawer at the AC
inlet. To change the fuse, unplug the AC cord first, pull out the fuse drawer and replace the fuse ONLY with a fuse of same voltage
and rating. If the fuse blows again after replacement, hand over the unit to qualified service personnel.
57. Power ON switch:
It is used to switch ON and OFF the unit.
6. Rear Section:
