Studio Technologies 371A, Руководство пользователя

Страница: 20 / 21

Issue 1, June 2018 Model 371A User Guide
Page 20 Studio Technologies, Inc.
MODEL 371A
INTERCOM BELTPACK
comparison chart is available on the
Studio Technologies website. In addition,
the following text provides a summary of
the changes:
• All configuration selections for the
Model 371A are performed using the ST-
controller software application. STcon-
troller also allows the version numbers
of the Model 371A’s application firm-
ware (embedded software) and Ultimo
firmware to be remotely identified.
• Support for electret microphones was
added to the Model 371A. This involved
adding a 5 volt DC power source to the
microphone input circuitry. This power
source can be enabled or disabled as
required using STcontroller.
• The configurable microphone input gain
settings were modified to be compatible
with the increased output level supplied
by electret microphones.
• The DIP switch assembly on the Model
371 is not present on the Model 371A.
As such the belt clip no longer needs
to be rotated and its mounting arrange-
ment has been changed.
• The user-accessible sidetone trim po-
tentiometer found on the Model 371
is not present on the Model 371A. In
the Model 371A the level of the side-
tone function is configured using
STcontroller.
• The Model 371A offers a second meth-
od of activating the mic kill function. This
allows a data signal, in additional to the
Device ID command, to activate mic kill.
• The STcontroller software application
now offers the ability to configure the
mic kill function, including allowing it to
be disabled.
Belt Clip
The belt clip is attached to the back of the
Model 371A’s enclosure by way of two 6-32
thread, Philips-head machine screws. Un-
like other the original Model 371 Intercom
Beltpack units, the belt clip on the Model
371A will never have to be rotated as part
of the configuration process. (There are no
configuration DIP switches under the belt
clip.) But if the belt clip does need to be
replaced a #1 Philips-head screw driver
would be the correct tool to remove the
machine screws.
Restoring Factory Defaults
A command in the STcontroller software
application allows the Model 371A’s con-
figuration to be reset to the factory default
values. From STcontroller select the Model
371A for which you want to restore its
defaults. Select the
Device
tab and then
select the Factory Defaults feature. Then
click on the OK box. The values shown on
the screen should reflect the default values.
They are:
Microphone Input Type: Dynamic
Microphone Preamplifier Gain:
Low (42 dB)
Sidetone Level: Medium
System Mic Kill: Device ID/Global Kill
Command
Button Operation – Channels 1 and 2:
Push to Talk/Tap to Latch