Studer Xtender BTS-01, Руководство пользователя

Страница: 12 / 49

STUDER Innotec
Xtender
10 V.3.1.0 User manual
Pos. Denomination Description Comment
1
ON/OFF
Main switch
Main on/off switch
See chapter 7.1 - p 29.
In XTM series, this function is deported on
the remote command module RCM-10.
See chap.6.4.3 – p.28
2 Temp. Sens
Connector for the battery
temperature sensor See chapter 6.4.2 – p. 28.
Only connect the original Studer BTS-01
sensor
3 Com. Bus
Double connector for
connecting peripherals such as
the RCC002/03 or other
Xtender units
See chapter 4.5.9 – p. 17.
The two termination switches (4) for the
communication bus both remain in
position T (terminated) except when
both connectors are in use.
4
O / T
(Open /
Terminated)
Switch for terminating the
communication bus.
5 --
3.3 V (CR-2032) lithium ion type
battery socket
Used as a permanent supply for the
internal clock. See chapter The real time
clock 6.2.11 - p 25.
6 --
Jumper for programming the
off/on switch by dry contact
See chapter 6.2.12 – p. 24 and fig. 8b
point (6) and (7). They are positioned at
A-1/2 and B-2/3 by default
7
REMOTE
ON/OFF
Entry command terminals..
In XTM series, this entry is
deported on the remote
command module RCM-10.
See chap. 6.4.3 – p. 28
Allow to dive a function – to be defined
by programming – by the closing of a dry
contact or by the presence of a voltage
across these terminals. See chapter
6.2.12– p. 24).
8
AUXILLARY
CONTACT
Auxiliary contact (See chapter 6.2.10– p. 24)
Take care not to exceed the admissible
loads
9 -- Activation indicators for
auxiliary contacts 1 and 2
See chapter 6.2.10– p. 24
10 L1/L2/L3 Phase selection jumpers.
See chapter 6.3.1. – p.26.
Jumper default at position L1
11 +BAT Positive pole battery
connection terminals
Carefully read chapter 4.5 – p.14
Take care with the polarity of the battery
and when tightening the clamp.
12 -BAT Negative pole battery
connection terminals
13 AC Input
Connection terminals for the
alternative power supply
(generator or public network)
See chapter 4.5.7 - p. 17.
Note: It is imperative that the PE terminal
be connected.
14 AC Output
Connection terminals for the
device output.
See chapter 4.5.6 - p. 17.
Note: Increased voltages may appear
on the terminals, even in the absence of
voltage at the input of the inverter.
15 RCM-10 Connector for RCM-10 module Only on XTM. See chap. 6.4.3 – p.28
4 CABLING
The connection of the Xtender inverter / charger is an important installation step.
It may only be carried out by qualified personnel and in accordance with the applicable local
regulations and standards. The installation must always comply with these standards.
Pay attention that connections are completely tightened and that each wire is connected at the
right place.