12
USE HEADPHONES (NOT INCLUDED)
LLE
ED
D LLIIG
GH
HTT S
SH
HO
OW
W
R
RE
ES
SE
ETTTTIIN
NG
G TTH
HE
E U
UN
NIITT
CARE AND MAINTENANCE
Inserting the plug of your stereo headphones (not included) into the headphone jack located on
the top panel will enable you to listen in private. When using headphones, the speakers will be
disconnected.
Read this Important Information before Using Your Headphones
1.) Avoid extended play at very high volume as it may impair your hearing.
2.) If you experience ringing in your ears, reduce the volume or shut off the unit.
3.) Keep the volume at a reasonable level even if your headset is an open-air type designed to
allow you to hear outside sounds. Please note that excessively high volume may still block
outside sounds.
- To turn off the LED light show, press and hold the LIGHT SHOW button.
- To turn on the LED light show, press and hold LIGHT SHOW button again.
Note:
If the brightness is glaring, turn on room lights or turn off LED light show.
1.
Do not subject the unit to excessive force, shock, dust or extreme temperature.
2.
Do not tamper the internal components of the unit.
3.
Clean your unit with a dry cloth. Solvent or detergent should never be used.
4.
Avoid leaving your unit in direct sunlight or in hot, humid or dusty places.
5. Keep your unit away from heating appliances and sources of electrical noise such as
fluorescent lamps or motors.
6.
If drop-outs or interruptions occur in the music during CD play, or if the
CD fails to play at all, its bottom surface may require cleaning. Before
playing, wipe the disc from the center outwards with a good soft
cleaning cloth.
CLEANING THE UNIT
•
To prevent fire or shock hazard, disconnect your unit from the AC power source when
cleaning.
•
The finish on the unit may be cleaned with a dust cloth and cared for as other furniture, Use
caution when cleaning and wiping the plastic parts.
•
If the cabinet becomes dusty wipe it with a soft dry dust cloth. Do not use any wax or polish
sprays on the cabinet.
•
If the front panel becomes dirty or smudged with fingerprints it may be cleaned with a soft
cloth slightly dampened with a mild soap and water solution. Never use abrasive cloths or
polishes as these will damage the finish of your unit.
CAUTION:
Never allow any water or other liquids to get inside the unit while cleaning.
In case of malfunction due to electrostatic discharge, reset the unit by press and hold POWER
button about 8 seconds to reset the unit. The unit will power down and power up to normal mode.
Содержание SB2145
Страница 1: ......