Stuart Turner Mainsboost MB 100CV, Инструкция по установке, эксплуатации и обслуживанию

Страница: 12 / 20

- 12 -
Pipe
Size
Minimum pipe length required to install the
upstream line-in kit (mm) (A)
22 mm 203 mm
28 mm 203 mm
Note: Do not forget if a water softener is to be installed this has to be
included in this pipe run, and additional space must be allocated for this.
Do not fit smaller pipework than the upstream line-in kit accepts as this will
impair performance.
Step 2a:
Monobloc Upstream line-in kit (22mm & 28mm)
The Monobloc upstream line-in kit includes:
1 - Monobloc unit
2 - Pressure gauge (upstream)
3 - Pressure gauge (downstream)
4 - Mainsboost vessel connector (See step 1)
5 - Isolation valve (See step 1)
NOTE: the Monobloc can be installed either horizontally or vertically but not upside
down. There are pressure gauge ports on both sides of the Monobloc to allow the
pressure gauges to be visable in any orientation. Follow the directional flow arrows
on the Monobloc to ensure correct installation.
3 2
1
Inlet
A
Outlet
  


Fig. 10a