Stryker Secure Connect Connected Hospital 5212, Руководство по эксплуатации и техническому обслуживанию

Страница: 10 / 44

IIn nsstta alllla attiio on n
IIn nsstta alllliin ng g S Se eccu urre e C Co on nn ne ecctt
T To oo ollss rre eq qu uiirre ed d::
• #2 Phillips screwdriver
• #1 Phillips screwdriver
• Straight pick
• Tape measure
• Level
• Pencil
• Tools required for hospital supplied fasteners
P Prro occe ed du urre e::
1. Record the S Se eccu urre e C Co on nn ne ecctt BBID ( Serial number location (page 5)) and room number/patient position on the S Se eccu urre e
C Co on nn ne ecctt association form (page 38).
2. Using a straight pick, configure the SB1 and SB2 dip-switches (A) to match the nurse call system and nurse call
communication cable (Figure 2).
C CA AU UT TIIO ON N -- Always match the dip-switches on SB1 and SB2 to the connected product configuration to avoid the risk of
head wall damage.
N No otte e -- To confirm dip-switch configuration, contact Stryker customer service or technical support ( Contact information
(page 5)).
A B
C
F Fiig gu urre e 2 2 –– S Sw wiittcch h cco on nffiig gu urra attiio on n
3. Using a straight pick, turn the S Se eccu urre e C Co on nn ne ecctt O ON N//O OF FF F switch (B) to the O ON N position (Figure 2).
4. Install the two supplied IPX labels (C) over the dip-switch and the O ON N//O OF FF F cutouts located on the back of the S Se eccu urre e
C Co on nn ne ecctt (Figure 2).
5. Using a tape measure and pencil, mark the center of the product location between 4 in. - 5 in. (10.2 cm - 12.7 cm) from
the floor (Figure 3).
N No otte e -- The marked mounting location on the wall must be within 0.5 in. (1.3 cm) left or right from the center line of where
the product will be positioned for the S Se eccu urre e C Co on nn ne ecctt to work properly.
EN 6 5212-009-201 Rev A.0