Stryker Quantum LED Surgical Headlights, Инструкция по эксплуатации

Страница: 4 / 8

EN F20006 Rev E
4
www.goenova.com
INTERVAL INSPECTION CRITERIA ACTION
Before
Use Inspect equipment for damage, wear, or
missing components.
Inspect power cord and twist cable for
cuts or punctures.
Inspect headlight lens for scratches.
Inspect the power pack housing for cracks.
If damage is
apparent, replace
the equipment.
Lorem ipsum
Instructions
Inspection and Testing
Only individuals trained and experienced in the maintenance of reusable
medical devices should inspect and test this equipment.
DO NOT use any equipment if damage is apparent or the inspection criteria
are not met.
DO NOT disassemble or service this equipment, unless otherwise specified.
Perform recommended inspection and testing as indicated in the Inspection
and Testing section.
ALWAYS operate the equipment within the specified environmental condition
values. See the Specifications section.
This equipment is suitable to use in a professional healthcare facility environment.
DO NOT cut or puncture the twist cable.
ALWAYS turn the light source power off before connecting or disconnecting
the twist cable to or from the LED surgical headlight.
ALWAYS hold the strain relief near the end of the twist cable when connecting
or disconnecting the twist cable from the light source.
DO NOT scratch the LED surgical headlight lens.
DO NOT stretch or kink the twist cable. Failure to comply will damage the
twist cable and reduce the light output permanently.
NOTE: Headband position will vary from person to person depending on head
size and personal comfort preferences.
CAUTIONS:
To Don a LED Surgical Headlight
Connect the LED surgical headlight power cable to the appropriate twist cable
(figure 2). See the Accessories section.
NOTE: To disconnect the power cable, twist the connector sleeve back before
separating the connector plug and receptacle (figure 2).
DO NOT connect the twist cable to the power pack before donning the LED
surgical headlight.
1.
Loosen the headband adjustment knob on the top and back of the LED
surgical headlight (figure 3). 2.
Put the LED surgical headlight on your head and turn the headband knob on
the top and back to secure the LED surgical headlight (figure 4). When using
loupes, put them on after this step.
NOTE: Make sure the LED surgical headlight fits securely on top of your head
and that the light is coaxial to your line of sight (figure 5).
3.
To Use a LED Surgical Headlight
Plug the twist cable connector into the jack on the power pack (figure 6).
Press the power button on top of the power pack (figure 7).
Press the variable control buttons (”+” and “-”) to adjust the light intensity.
See the
Troubleshooting section if required (figure 8).
1.
2.
3.
To Doff a LED Surgical Headlight
Turn the power pack off.
Loosen the headband knobs on the top and back of the LED surgical headlight
and remove the LED surgical headlight from your head.
Clean the LED surgical headlight and cord. See the Cleaning section. To clean
the PP4 Power Pack, see the instructions for use supplied with the PP4
Charging Base Station.
1.
2.
3.
NOTE: For service, contact your
Enova's
sales representative or call
Enova's
customer service.
NOTE: If any component must be discarded, see the Disposal / Recycle
section.
WARNINGS: WARNINGS: