6209-001-708 Rev-E
EN
www.stryker.com
9
1. Ensure the drive pins are free from all obstructions
during operation (see figure 6).
Drive
Pins
Figure 6 – Drive Pin Clearance
2. Slide the FAST/STD/Safe control to the FAST or STD
mode position to allow the handpiece to operate.
3. Squeeze the pressure sensitive trigger for variable
speed operation.
4. Slide the FAST/STD/Safe control to the safe mode
position when you are finished operating the
handpiece.
To Operate Handpiece
WARNINGS:
• ALWAYS place the FAST/STD/Safe control in the
safe mode position while the handpiece is idle,
before installing or removing any accessory, or when
passing the handpiece to another person.
• DO NOT place a hand on the drive pins located on
the blade mount of the handpiece. Friction between
the drive pins and hand may create heat.
• DO NOT apply excessive pressure, such as bending
or prying, with a cutting accessory to prevent
fracturing and/or excessively heating the accessory.
CAUTIONS:
• DO NOT stall the handpiece. Failure to comply may
damage the electric motor and/or battery pack. If
the handpiece jams, release the trigger immediately.
Remove any obstructions before continuing the
procedure.
• If any power loss is experienced while using a
handpiece, ALWAYS replace the battery pack with
a fully charged battery pack. Failure to comply may
result in a drained or damaged battery pack with a
shortened life.
