P
Prro
occe
ed
du
urre
e::
1. Raise the head section to the highest position.
2. Lower the rails all the way down.
3. Apply the brakes.
4. Using a #2 Phillips screwdriver, remove the nine screws (B) that secure the protective plate (A) to the litter frame (Figure
23). Save the screws.
5. Using two 7/16” combination wrenches, loosen the two nuts that secure the cable to the activation lever (D) (Figure 23).
Remove the cable from the activation lever. Save the cable and nuts.
6. Using a 5/32 in. Allen wrench and a 7/16” combination wrench, remove the locknut, washer, and shoulder screw (C) that
secure the activation lever to the litter frame (Figure 23). Remove and discard the activation lever. Save the locknut,
washer, and screw.
A
B
D
C
C
F
Fiig
gu
urre
e 2
23
3 –– H
He
ea
ad
d sse
eccttiio
on
n a
accttiivva
attiio
on
n lle
evve
err
7. Install the new activation lever and reconnect the cable end to the lever.
8. You must adjust the cable end nuts for the head section to function. Make sure that the activation lever is secure after
adjustment.
9. Reverse steps to reinstall.
10. Verify proper operation before you return the product to service.
L
Liitttte
err rre
em
mo
ovva
all,, ffiixxe
ed
d b
ba
asse
e
T
To
oo
ollss rre
eq
qu
uiirre
ed
d::
•
#2 Phillips screwdriver
•
(2) 1/2” combination wrench
•
(2) Bungee cords (or equivalent)
•
(4) Sawhorses (or equivalent)
P
Prro
occe
ed
du
urre
e::
1. Raise the rails to the highest position.
2. Apply the brakes.
3. Using sawhorses, support each end of the litter frame.
EN
36
1900-009-002 Rev AA.6
