8. Move the whole assembly slightly toward the center of the product.
9. Using an 11/16” combination wrench, remove the two nuts (K) that secure the threaded end of the cylinder to the
bracket (Figure 20). Remove the pneumatic cylinder. Save the nuts.
N
No
otte
e -- Apply medium strength thread locker to the two bolts and the two nuts before installation.
10. Reverse steps to reinstall.
11. Verify proper operation before you return the product to service.
H
He
ea
ad
d sse
eccttiio
on
n a
assssiisstt cca
ab
blle
e rre
ep
plla
acce
em
me
en
ntt
T
To
oo
ollss rre
eq
qu
uiirre
ed
d::
•
(2) 7/16” combination wrench
•
#2 Phillips screwdriver
P
Prro
occe
ed
du
urre
e::
1. Raise the head section to the highest position.
2. Lower the rails all the way down.
3. Apply the brakes.
4. Using a #2 Phillips screwdriver, remove the nine screws that secure the protective plate to the litter frame (Figure 16).
Remove and save the protective plate. Save the screws.
5. Using two 7/16” combination wrenches, loosen the two nuts (A) at the ends of the defective cable in order to remove it.
Take note of the cable path and how the ends are mounted at their tie points (Figure 21). Remove the cable.
Head section assist cable path.
A
C
C
B
A
F
Fiig
gu
urre
e 2
21
1 –– H
He
ea
ad
d sse
eccttiio
on
n a
assssiisstt cca
ab
blle
e
6. Install the new cable.
7. Adjust the two nuts at each cable end. Make sure that the adjustment at the activation lever end is tight and the
adjustment at the activation flap end presses the activation flap against the cylinder release pin without activating it.
EN
34
1900-009-002 Rev AA.6
