B
A
F
Fiig
gu
urre
e 5
5 ––
7. Reverse steps to reinstall.
8. Verify proper operation before you return the product to service.
C
Ca
asstte
err rre
ep
plla
acce
em
me
en
ntt,, h
hyyd
drra
au
ulliicc b
ba
asse
e
T
To
oo
ollss rre
eq
qu
uiirre
ed
d::
•
Floor jack
•
3/4” socket
•
11/16” socket
•
3/4” combination wrench
•
5/8” combination wrench
•
(2) Bungee cords (or equivalent)
P
Prro
occe
ed
du
urre
e::
1. Raise all siderails to the highest position.
2. Lift the base hood.
3. Separate the V
Ve
ellccrro
o® fasteners that secure the base hood to the base.
4. Using bungee cords, support the base hood.
5. Using a floor jack, raise the end of the product near the caster that needs repair approximately nine inches off the floor.
6. Using a 5/8” combination wrench and 11/16” socket, remove the nut and bolt that secure the caster to the caster horn
(A) (Figure 6). Save the nut and bolt.
7. Using a 3/4” socket and 3/4” combination wrench, remove the locknut (B), base hood support (C), caster adjusting
socket, washer, and bolt that secure the caster to the base (Figure 6). Discard the caster. Save all other parts.
EN
14
1900-009-002 Rev AA.6
