8
www.stryker.com
EN
7110-120-700 Rev-AB
Figure 11 – Replace Message and Symbol
Figure 12 – Total Number of
Over Temperature Events
Figure 13 – Total Time Exposed to
Over Temperature Conditions
Cleaning
To Clean the Battery Charger and
Charger Modules
WARNING:
Before cleaning, ALWAYS
disconnect the power cord from the facility
power receptacle and the battery charger
to reduce the risk of electric shock.
CAUTIONS:
• DO NOT immerse the battery charger or
charger modules in liquid.
• DO NOT use solvents, lubricants, or other
chemicals to clean the battery charger or
charger modules unless otherwise directed.
NOTE:
If the battery pack fails the state-of-health
test, a REPLACE message and symbol will appear
(figure 11). See the
Troubleshooting
section.
2. Store the battery pack on the battery charger
to maintain a full charge before sterilization.
To Access Over Temperature
Information
NOTES:
• Specific types of battery packs allow you
to access information about battery pack
exposure to over temperature conditions.
• The information screen will return to its origin
after displaying an over temperature message
screen for five seconds.
1. From the READY, CHARGING, or REPLACE
message screen, press the MORE button to
access the # of OVER TEMP message screen.
The counter will display the number of times
the battery pack has been exposed to an over
temperature condition (figure 12).
2. Press the MORE button again to access the
TIME OVER TEMP message screen. The
counter will display how much time, in minutes,
the battery pack has been exposed to over
temperature conditions (figure 13).
To Disconnect the Battery Charger
CAUTION:
To reduce the risk of damage to the
power cord, ALWAYS pull the power cord plug, not
the power cord when disconnecting the battery
charger.
Disconnect the battery charger from the facility
power receptacle and Ethernet receptacle, as
required.
To Replace a Charger Module
See the instructions for use supplied with the
replacement charger module.
