30
6086-009-001 REV B
www.stryker.com
Operation Guide
LOADING THE COT INTO A VEHICLE WITH TWO OPERATORS
WARNING
•
Two operators must be present when the cot is
occupied.
•
Operators must be able to lift the total weight of the
patient, cot and any items on the cot.
•
The higher an operator must lift the cot, the more
difficult it becomes to hold the weight. An operator
may need help loading the cot if he/she is too short
or if the patient is too heavy to lift safely. The operator
must be able to lift the cot high enough for the cot
legs to unfold completely and lock when the cot is
unloaded. A shorter operator needs to raise their arms
higher to enable the undercarriage to unfold.
•
Ensure proper hand placement on hand grips. Hands
should be clear of red safety bar pivots while loading
and unloading the cot or whenever changing height
position of the cot with two or more operators.
•
There must be a safety hook properly installed in the
vehicle so that the bumper does not interfere with the
front legs of the base frame. (See
for safety
hook installation instructions.)
•
Failure to install the safety hook can cause injury to the
patient or operator. Install and use the safety hook as
described on
.
To load the cot into a vehicle with two operators:
1. Place the cot in a loading position (any position where
the loading wheels meet the vehicle floor height). Roll
the cot to the open door of the patient compartment.
Lift the vehicle bumper to the raised position (if
equipped).
2. Push the cot forward until the loading wheels are
on the patient compartment floor and the safety bar
passes the safety hook as shown in Figure 18.
3. For maximum clearance to lift the base, pull the cot
back until the safety bar engages the safety hook.
Operator 2 should verify that the bar engages the
safety hook.
4. Operator 1
− Grasp the cot frame at the foot end. Lift
the foot end of the cot until the weight is off of the
latching mechanism. Squeeze and hold the release
handle (A or B, as shown in Figure 13 on
).
5. Operator 2
− Stabilize the cot by placing your hand on
the outer rail (C). Grasp the base frame where indicated
(D). After the foot end operator lifts the cot and
squeezes the release handle, raise the undercarriage
until it stops in the uppermost position and hold it there
(see Figure 19). The foot end operator should release
the handle to lock the base in the retracted position.
6. Both Operators
− Push the cot into the patient
compartment (see Figure 20), engaging the cot fastener (not included).
Figure 18: Safety Bar Engaging the Safety Hook
Figure 20: 2 Operators with Base Full Up
Figure 19: 2 Operators with One Lifting the Base
Содержание 6086
