Struers Discotom-6, Инструкция по эксплуатации

Страница: 14 / 149

Discotom-6
Instruction Manual
10
Discotom-6 is provided with various light diodes indicating the status
of the machine. Beep signals will sound if a key is pressed when the
function cannot be activated.
Status Indication Comments
Green POWER indicator on
The main power switch has been
turned on.
White AUTO indicator on
AUTO mode is active.

Beep signal
You pressed AUTO, START

,
FORWARDS

or BACKWARDS

while the motor was running.
2 long

Beep signals
You pressed START

while the
protection guard was open.
3 long

Beep signals
You pressed START

for cutting
while cooling valve isn’t in cutting
position.
Turn cooling valve to cutting position.
Red

indicator on
The emergency stop has been
pressed. Release the emergency stop to shut off
the

indicator.
Red

indicator on and

beep signal
The emergency stop has been
pressed and you tried to press
another key.
Yellow FEED SPEED
REDUCED indicator blinking
In AUTO mode: the feed speed is
too high. The machine automatically turns the feed
speed down.
An AUTO cut has finished. Feed
speed reduced. Turn the feed speed down or press any
key.
Red

and yellow FEED
SPEED REDUCED indicators
blinking
Cutting in AUTO mode not possible
as the cutting table does not move. Press any key to stop the indicators.
Material may be too hard for the cut-off
wheel chosen or cutting table may be
jammed. See Trouble Shooting section at
back of manual.
Red

indicator and 1 red
cell on LOAD BAR
Pump motor overloaded. Stop the machine. Push the red button on
the back of the machine to reset the
safety cut-out.
Red

indicator and 2 red
cells on LOAD BAR
Main motor overloaded. Process
halted. The indicators will disappear when the
motor has cooled down.
Red

indicator, 2 red cells
on LOAD BAR and

beep
signal
You tried to press a key before the motor
had cooled down.
Light Diode and Beep Signals