5
START-UP AND OPERATION
Merchandiser Start-Up
Do not use an extension cord with this
appliance.
Do not operate this equipment with a damaged
cord, plug or outlet.
Insure the main power switch is off.
Plug cord into a certified 120V electrical outlet
with ground.
Turn main power on.
Remove upper front panel (See maintenance
for panel removal). Switch is on the right
side of case.
Coil fan should turn on.
From inside of the case, check for discharge
air from front baffle, to confirm that the fans
are functioning properly.
When the case is in a start up mode or has
been idle for a long period of time, the unit
will require 75 minutes in order to pull-down
temperature.
The lights should come on at the same time.
First time lighting may require a short warm
up period for the bulbs. Slightly dim or a
flickering of new bulbs is normal.
It is recommended that the self contained
refrigerated cases maintain front and rear
airflow clearance of approximately six inches.
Obstruction or restriction of air can void
warranty.
The interior case temperature reaches 2 °C to
5 °C / 35 °F to 41 °F.
Note:
The case temperature is set at the
factory, as determined by the case size.
The temperature is controlled by a
thermostat. If a temperature setting change
is required, refer to the instructions for the
Temperature Control Programming operating
section of this manual.
Note: Set point should be 4.5
°C /
40 °F. This
will maintain the product temperature range.
Settings lower than 4.5
°C /
40 °F can cause
food items to freeze
.
Main Power Switch
