REMOVAL FROM SKID / ADJUSTING LEVELERS
4
1. Remove Unit From Skid
Remove case from skid and place into
proper position.
To prevent damage, support case while
sliding skid out from under case.
Note:Illustration at right reflects general
outline of sample case and does not reflect
any particular model or options).
Support
case while
removing
from skid.
Slide
Skid
Out
Pry Bar
Base
Frame
Leveler
Adjustable
Wrench
Toe-Kick
Block
2. Cases With Levelers: Adjust Levelers
After case is in position, adjust case so it is level
and plumb (see illustration at right).
You may need to remove front and/or rear
Toe-Kick to access levelers.
Use adjustable wrench (and possibly a pry bar)
to adjust leveler.
Do not use pry bar on toe-kick (it may buckle).
Do not use pry bar on end panel (it may chip).
Use pry bar ONLY on base frame to avoid
damaging case.
Use a block to reach base frames with pry bar.
See illustration below.
