Page 6 of 10
STEP 2
Place the SHELF (A) on its side and slide the (4) BOTTOM
POLES (C) through the corner cylinders of the SHELF (A). Make
sure that the SHELF (A) corner cylinders are positioned over the
SLIP SLEEVES (E).
Take 2 SCREWS (F) and put them through the bottom of the
BASE (D), the side with the feet levelers, and fasten them to
BOTTOM POLES (C). Tighten the SCREWS (F) with the ALLEN
KEY (G).
Repeat with the other BASE (D).
STEP 3
Stand the unit upright and push each corner of the SHELF (A)
until the top of the SLIP SLEEVES (E) are flush with the top of
the corner cylinders on the SHELF (A).
Note: The level side of the SHELF (A) is the TOP side (the
Strongway logo on the corner cylinders should be right-side up)
Use a rubber mallet, if needed, to secure the SHELVES (A).
STEP 4
Install the next set of SLIP SLEEVES (E) on the (4) BOTTOM
POLES (C) in the next position up from the bottom. Place
another SHELF (A) over the BOTTOM POLES (C) and secure
the SHELF (A) so the top of the SLIP SLEEVES (E) are flush
with top of the corner cylinders on the SHELF (A).
Repeat until all shelf positions on the BOTTOM POLES (C) have
a SHELF (A).
STEP 5
Screw the TOP POLE (B) into the BOTTOM POLE (C). The tops
of the TOP POLES (B) are indicated by the BLACK END CAP.
Make sure all (4) TOP POLES (B) are screwed on tightly.