Page 9 of 16
when touched.
Keep plenty of fresh water, soap and a supply of baking soda on hand in the area of the batteries
in case of contact with battery acid. Baking soda neutralizes lead acid battery electrolyte.
The product is supplied with a rechargeable, sealed lead acid battery. This battery is self-
contained and not consumer replaceable. Batteries must be disposed of properly when they no
longer hold a charge.
Operating Instructions
⚠
WARNING
SPARK AND EXPLOSION HAZARD
Risk of explosive gases. Working in the vicinity of a lead acid battery is dangerous. Batteries
generate explosive gases during normal battery operation. Do not smoke, use matches, or a
cigarette lighter while near batteries. Do not handle the battery while wearing vinyl clothing. The
static discharge from vinyl clothing rubbing together may ignite explosive gases, causing injury
and/or property damage.
Do not operate the jump starter in compartments containing batteries or flammable materials, or in
locations that require ignition-protected equipment.
The 12V DC outlet does not automatically turn off the power supply to the DC appliance, even if
the internal battery of jump starter is discharged.
Disconnect the 12V DC appliances after use to avoid over discharge of
jump starter’s internal
battery.
Operation of 12V DC Appliances
1. Check battery capacity status by pushing the battery capacity check button to ensure that the
battery is fully charged.
2. Open the 12V DC outlet plastic cover. Plug the power cord of the DC appliance into the 12V DC
outlet.
3. Turn ON the DC appliance.
4. Please disconnect the 12V DC appliances after use to avoid an over-discharge of the
jumpstarter
’s internal battery.
5. Recharge the jumpstarter immediately after use.
Operation of USB Devices
1. Check battery capacity status to ensure the battery is fully charged.
2. Plug one end of USB cable (not provided) into the USB power port and other end to the USB-
chargeable device e.g. MP3 player.
3.
Slide the USB/LED slide switch to the left. The USB power indicator will glow to indicate that
the USB power port is activated.
4. Slide the USB/LED switch to middle to turn off USB after use. Failure to do so may damage the
internal battery because of over discharge.
5. Recharge the jumpstarter immediately after use.
⚠
CAUTION
