Scan Select:
Select All Sat to search all satellites you have selected in the
Satellite Setting
menu. Select Single Sat to search only the satellite selected under
Satellite
.
After configuring, press
GREEn
to start scanning with the selected settings.
Your receiver will now perform an automatic channel search with the scanning progress shown
on screen. During the channel search you can quit the scan process with
EXIT
or
MEnU
. When the
progress has been completed, all found channels will be stored and the receiver will switch to the first
found channel.
7.1.5 Manual scan - Scanning by transponder
Select the options if you want to do a manual scan. (Advanced users.)
Satellite:
Select the satellite you wish to scan from, as previously set up in the
Satellite
Setting
menu.
Frequency:
Enter a known frequency of a satellite transponder with the
0 ~ 9
buttons on
the remote.
Symbol Rate:
Enter the symbol rate of the previously set satellite transponder with the
0 ~
9
buttons on the remote.
Polarity:
Set the polarization of the previously set satellite transponder, V (Vertical) or
H (Horizontal).
NIT:
Select On if you want to do a scan starting from the previously set satellite
transponder according to the Network Information Table, as offered by the
Satellite Provider. Select Off, to scan just the one transponder.
Programme:
Select Free Only to search for Free to Air channels. Select All to include
scrambled channels as well. Note: Scrambled channels cannot be watched
with this receiver.
After configuring, press
GREEn
to start scanning with the selected settings.
Your receiver will now perform a channel search with the scanning progress shown on screen. During
the channel search you can quit the scan process by pressing
EXIT
or
MEnU
. When the progress has
been completed, all found channels will be stored and the receiver will switch to channel number 1.
The new found channels are added to the end of the list.
Satellite Finder:
You can use the menus
Satellite Setting
,
Automatic Sat Scan
or
Manual Scan
to
find a satellite and peak the dish for maximum reception. Select the satellite
you wish to find or peak, select the settings according to your dish-setup and
then select a transponder which is known to carry a signal. Use the signal and
quality bar to find/peak the satellite. Signal strength and quality above ~70%
would be considered usable.
7.1.6 Information
Find technical information about this receiver as model, hardware and software versions. This
information might be asked for if you contact us.
7.2 Channel
Press
MEnU
and select
Channel
by pressing the
tu
buttons. Use the
pq
buttons to select the
TV
Channel Editor
submenu. Press
ok
to edit programme settings. Press
EXIT
to exit the menu.
15
English
PART 2 • English