Strong SRT 7000, Руководство пользователя

Страница: 14 / 25

11
PART 1 • English
English
7.1.3 Sort
Here you can sort your channels in the following orders:
Default Sort the channels in the original order
By Service Name Sort the channels in alphabetical order (A-Z)
By Frequency Sort the channels in frequency order (Low-High)
By Encrypt Sort the channels from free to scrambled
7.2 Picture
Press MEnU then select Picture . The menu provides options to adjust the video settings. Press
pq
to
select an option and tu to adjust the setting. Press EXIT to exit the menu.
Aspect Ratio
The default and recommended format is
Auto . You can also set the display format to further available
options like 4 : 3 Full Screen , 4 : 3 Pan & Scan , 4 : 3 Letter Box and 16 : 9 Wide Screen .
4 : 3 Letter Box the full 16:9 picture will be displayed on your 4:3 TV set with black bars above
and below the picture.
4:3 Pan & Scan the centre of the 16:9 picture will be displayed full-screen on your 4:3 TV
4 : 3 Full Screen combination of Letter-box and Pan & Scan .
16 : 9 Wide Screen select when use a 16:9 TV set.
TIP: You can change the video output format directly from viewing mode by pressing the
YElloW button on the remote control.
Resolution
If the video does not appear correctly, change the setting. These settings match the most common
settings for HDMI.
480i: for NTSC system TV.
480p:
for NTSC system TV.
576i: for PAL system TV.
576p: for PAL system TV.
720p: for NTSC or PAL system TV.
1080i: for NTSC or PAL system TV.
TIP: You can change the video resolution directly from viewing mode by pressing the gREEn
button on the remote control.
Tv format
Set the standard corresponding to your TV set. Available options are:
Auto , PAL and NTSC .
video output
This setting is only relevant when the receiver is connected to the TV set via Scart. Select
RGB for the
best picture quality or CVBS in case your TV doesn’t support RGB .
loop Through (vCR to Tv Scart)
This option is only relevant if you have a device (Video-/DVD-recorder) connected to the VCR scart
connector of your receiver. It´s signal will be looped through to the TV scart output of your receiver. Use
this option to set the preferred loop-through mode.
Running mode : The Loop through will be switched off when the receiver is in Standby mode.
Always : The Loop through is always on – in Operation and in Standby mode.
Switching between DTV/VCR contents in Operation mode is realized by using the DTv/vCR button on
the remote control. “AV IN” will be displayed on the front LED when receiver is in VCR mode. Press DTv/
vCR button again to return to the digital TV content.
noTE: Setting “Always” increases the power consumption in Standby mode. The front panel
LED remains green in Standby!