PART 1 • English
14
5.3.5.1 STB to STB spftware transfer
1. First power off both STBs, connect them with cross RS-232.
2. Then power on master STB (master is STB from which you will copy software) and keep
slave STB off. Navigate in the menu of master STB and select
“System Update – STB to STB”.
3. When the status displays “detecting slave STB”, power on slave STB, after the master
STB detects the slave, the master starts transmission and burns.
4. While transmitting and burning, it is very important to avoid other operations such as
power off because this may cause destruction of the data in the FLASH memory and the
receiver will need to be repaired.
5. When update is complete, first power off both STBs, then disconnect the RS-232 line.
5.3.5.2 Over Air Download (OAD)
Select this option in order to update your receiver with the latest software version. Software update
service is available from satellites Astra 1C, 1E, 1F at 19E and Hotbird 1, 2, 3, 4 at 13E.
If your antenna is primed to Astra 1C, 1E, 1F at 19E then enter following parameters:
Frequency: 12603; Polarity: H (Horizontal); Symbol rate: 22000
If your antenna is primed to Hotbird 1, 2, 3, 4 at 13E then enter following parameters:
Frequency: 12476; Polarity: H (Horizontal); Symbol rate: 27500
Move menu focus to OK and press
OK
button on remote control. The receiver will check availability
of the software update on air and load the latest software, if available. Do not switch power off and
do not disconnect the receiver from the aerial during update process. Availability of the software
update is subject of local broadcast condition and may not work in all countries. Contact your
vendor to find out more about this function.
5.3.5.3 Update through PC to STB
1. Connect Computer to receiver (receiver must be power off) with a 9-pin cross cable
(two females).
2. The computer will follow the steps below:
Start->Programs->Accessories->Communications->Hyper terminal
Then choose “COM1” or “COM2” according to which port you are using in the computer
and port setting as follows:
Bits per Second:
115200
Data bits:
8
Parity:
None
Stop bits:
1
Flow Control:
None
3. In Hyper Terminal menu select “transfer” item and then press “send file” item. Select the
file with the new software (
*.UPD
) you want to download and choose the protocol
“1K X modem”. Finally press
OK
and a download menu will appear on the computer
screen. Power on the receiver, then the download process will start.
Содержание SRT 6016
Страница 1: ...User Manual Digital Free To Air Satellite Receiver SRT 6016 Picture similar...
Страница 2: ......
Страница 25: ...Environmental Issues...