5
PART 1 • English
En
gl
is
h
2.0 ConnECTIon
Connecting to Tv, Terrestrial Antenna, IR Eye and main Power
Fig. 1
To receive the broadcast signal, the terrestrial antenna cable should be connected to
the ANT IN connector at the receiver. Then connect the IR connector into the receiver
and make sure it is properly connected to the IR sensor input. Afterwards you can plug
the power adapter to the main power source (100 ~ 240 V, 50/60 Hz Auto detecting).
After all connections are established carefully, the IR eye LED must light, otherwise the
Remote Control will not react.
Connection to a usb device
Fig 2
Connecting to DvD Recorder
Fig 3
Connecting to a Projector
Fig 4
2.1 Default Pin-Code: 0000
3.0 YouR RECEIvER
Fig. 5
1. sCART PoRT
To connect to your TV set.
2. mini usb-Port
To connect your included converter USB cable and then your USB
storage device
3. AnT In
To connect an antenna for reception of broadcasting signal
(support antenna power 5 V DC).
4. To Tv
To connect to the areal input of your TV or to a second receiver.
5. IR sensor slot
To connect IR eye plug
6. DC In
To connect the power adapter plug (5 V DC/2 A).
3.1 Remote Control
Fig. 6
1.
Turns the receiver On/Standby
2. 0~9
Channel selection or value input
3.
Mutes audio output of the receiver
4. RECAll
Back to previous shown channel
5. PAgE+/PAgE- Page up/down
6. vol+/vol-
TV mode: Volume up/down; Menu mode: navigation & change settings
7. Ch+/Ch-
TV mode: Channel up/down; Menu mode: navigation
8. oK
TV mode: Displays the current channel list;
Menu mode: Activates the highlighted menu item.
9. mEnu
TV mode: Opens the main menu. Menu mode: You will get one step
back. Multimedia: Go to upper folder
10. EXIT
Exits from the menu or sub-menu
11. Info
Shows the actual channel information
12. sub
Shows list of subtitle languages
