Strong SR-WM-10U, Инструкция по сборке

Страница: 6 / 8

pg.6
SR-WM-10,12, & 16U Installation and Users Manual
5. Attaching to Wall
NOTE: The bolts to secure the rack to the wall are not included. It is strongly recommended
that a 3/8” lag bolt be used to mount the rack to the wall studs. If the location of the rack
does not line up with the studs, a 2x4 across the studs or a sheet of plywood attached to
the studs must be used to attach the rack to the wall.
THE USE OF MOLLYS OR ANCHORS IS NOT RECOMMENDED!
A. Locate wall studs using a stud finder (not included).
B. Position the provided mounting template on the wall in the desired location of the rack.
C. Level the template and mark the wall with the bolt locations.
D. Install the mounting bolts into the locations marked with the template. Leave the bolts loose enough for the brackets
to slide over the heads when hanging the rack. If the optional Swing Kit is being used, proceed to Step F.
E. Slide the wall rack assembly onto the lag bolts in the wall, then finish tightening the bolts in the wall.
CAUTION: This rack is intended for use only with Strong shelf models with a maximum
combined load of 250 pounds. Use with heavier than the maximum load indicated may
result in instability causing possible injury.