PART 1 • English
12
Symptoms
Check points
Er1 Message
(Over Current)
Or System Shut-down
n
Make sure there is no short-circuit of the wire connection.
n
Check if the Antenna is blocked by anything.
n
Make sure the Motor works well. Some times a malfunction
Motor can cause higher current.
n
Maybe the Antenna is too heavy. Please try to use our high-
power version.
Er2 Message (No Pulses)
n
Re-check the wire connection.
n
Make sure the actuator is not stopped by Mechanical Limit.
n
Check if the Reed Switch Sensor is broken.
n
Check if the Motor is broken.
Er3 / Er4 Message
(Internal Error)
n
Reset the positioner
Only the LED lights on and the
Positioner doesn’t work.
(No response)
n
Unplug the AC Power Cord from the AC outlet. Wait for
more than 10 seconds then re-plug.
n
This problem might be caused by the unstable AC power. In
order to protect the stored data, the Positioner will lock itself
under this situation. A voltage regulator might help.
Turn-Off Automatically
The Display will be turned-off while LNB power is off.
Can’t be Turned-off by optional
Remote Control or manual
Power button.
If the LNB power of receiver is switched-on, the positioner
can’t be turned-off.
