Stromag EZB, Инструкция по монтажу

Страница: 68 / 92

4.2 Operating conditions
The clutch is only to be engaged at standstill or close to synchronous speed of the inner body and armature
plate, but can be disengaged under a full load and at any speed.
The size of the permissible relative speed between the clutch sides (A and B-side, see section 4.1) depends on
the accelerating centrifugal mass.
Designation Definition
Ambient temperature -5 °C to +35 °C
Relative humidity, max. 50 % at +40 °C
4.3 Dimensional drawing
NOTE
Stromag would like to emphasise that users should refer to the dimensional drawing for all technical
details, including: dimensions, weights, tolerances, tightening torques, and any other technical specifi-
cations and units required for assembly, such as securing equipment and lubricants.
Should this information be necessary during assembly, a reference will be made in the dimensional
drawing at the respective point in this documentation.
A dimensional drawing is supplied as a separate document and can also be requested from Stro-
mag's Customer Care. For this, the same product data is required as when ordering spare parts.
4.3.1 Tightening torques
CAUTION
Risk of accidents due to defective screw connections
Defective screw connections may lead to parts loosening, being slung away and severe or fatal inju-
ries.
► Guidelines of the machine or engine manufacturer for the screw connection with the clutch must
be adhered to.
► Only use screws of the required size, strength and quantity.
► Observe the tightening torque.
► Only use the specified liquid screw locking agent.
The tightening torques for the screws can be obtained from the dimensional drawing, see section 4.3.
The maximum transmitted torque must be checked by the machine or engine manufacturer.
4.4 Marking on the product
The following data can be found on the outside of the clutch:
• Order reference no.
• Type series and size
• output of the coil
• delivery date month/year/serial no.
• voltage
• air gap
16
Mounting instructions Electromagnetic tooth clutch EZB • No. 590-00000 E • 10/2017